Symbol: Select the abbreviation you want displayed for unit type you selected for Length. Mass Analysis tool used to display mass properties, or volume information for the solids and surfaces in your design.: Select the default units used for mass.ĭensity: Select Independent to specify the density units from the density fields or Derived to calculate the units from your selections for length and mass. Insert and can be connected to geometry by a note leader.: When radians are chosen, their angle dimensions will show the appropriate values and unit suffix (rad).

Note Annotation placed on a design, drawing sheet, or 3D markup.

For SCDM only, a checkbox to Use project units when available will be active only when you are modifying settings for all new documents. See the Small Units section below for notes about working with Micrometers, Nanometers, and Mils units.ĭecimal/fraction: If you use Imperial units, you can select Decimal or Fraction to display distance measurements that are less than 1 unit.Īngle: Select from the following options. Length: Select the default units used for length. Type: Select Metric or Imperial from the menu.

You can hover over the icon to see a tooltip that will explain the valid values for the option.

or the DS Mechanical Options dialog, you will see a red exclamation mark icon next to the field. If you try to enter a value that is out of the allowed range in the Options panel Area of the user interface that enables you to modify functions specific to tools.

Ansys spaceclaim change unit